Back in the saddle again!soon to be skidder!

[FreddyGearDrive]

Thanks Guys!
I think I might go w/Mr dremel cuttin wheel. Not sure how much I'm going to have to remove yet. Once all the crap is in,I'll know how much to wack by the looks of it.
The cab is made out of cast alum.
Found a home for one of the spool valves.


This is basically how the pump & batteries are going,except for one will be on top of the other,also on an angle due to hood angles.

Also shortend the pump tank.

This I don't believe it! Only took two shots at nose piece to git it right. BUT! The hood I got on the first shot





Can't wait to git the plow to go up & down. Now I've got to git fancy w/lift arms & levers,cause the lift cylinder is no where close to where it needs to be.For a simple deal.
Thanks for lookin!
FGD