|
|
|||||||
| Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
|
|
Thread Tools | Display Modes |
|
#11
07-31-2013, 06:32 PM
|
||||
|
||||
Re: Lattice Boom Crane Build (Wood)
Been working on the crane most of the day. Here it is so far, got a final short solid side tip section to finish, and figure out how and what to make the pulley sheeves from. The 1:50 Menck diecast is sitting behind it in one shot.
   Got the mount glued onto the base and plan to use 1/8 brass tube for the boom base pivot. Jim Last edited by Rvjimd; 07-31-2013 at 06:32 PM. Reason: Copy... 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode