He is at it again! 1:50 Dozer Conversion - RC Truck and Construction

		RC Truck and Construction > RC Truck's Odds and Ends. > Die-Cast Conversions Tech.
He is at it again! 1:50 Dozer Conversion

Die-Cast Conversions Tech. The tricks of installing drive line and electrical components into die-cast models.

Thread Tools

Display Modes

#10

09-09-2013, 07:00 AM

Rvjimd

Craftsman

Join Date: Dec 2012

Location: Des Moines, Iowa

Posts: 884

Re: He is at it again! 1:50 Dozer Conversion

Truck maker,

That was probably the pinion slipping on the plastic crown gear. I'm in the middle of yet another version. I'm making the rear end of the chassis out of aluminum angle stock so I can position the two drive motors where I want them and I'm using two steel pinions instead of one steel and one plastic crown.

Film at eleven!

Jim

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 09:38 AM.