|
|
|||||||
| Die-Cast Conversions Tech. The tricks of installing drive line and electrical components into die-cast models. |
|
|
Thread Tools | Display Modes |
|
#11
09-10-2013, 03:20 PM
|
||||
|
||||
Re: He is at it again! 1:50 Dozer Conversion
John,
Your diff and brake question is a good one! I don't know for sure, but the guys scratch building the bigger tracked machines are all using two motors I think? I would guess that getting the brakes to work as smoothly and easily as using two motors would be harder than the simple two motor setup. As you prowl around here on the site you will figure out the handful of guys with the bigger scratch machines and they should have a good answer. Jim 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode