|
Construction Equipment If it digs, pushes, hauls dirt "off road" post it here. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
John Deere swing machine 2954d
A few years back I made an excavator it was a first attempt but not very good, so I decided to have another go, I have completely remade the under carriage but for now have reused the old boom arm and bucket, hopefully in the future it will be replaced but seems ok at the moment.
Tracks are made from k1 attachment chain and tracks made from aluminium angle, my girlfriends dad then took them all to work and got them anodized. Motors are mfa como 970d planetarys 105:1, they are attached to angle grinder heads which have a 3:1 reduction, I may upgrade the Motors to brushless at some point to improve the travel speed slightly. I used a China cat slew bearing it work a ok but I don't think it will hold so I'm going to change it to a taper bearing set up and possibly 2 slew Motors. |
#2
|
||||
|
||||
Re: John Deere swing machine 2954d
Cool. Looks like a forestry machine. 1/10 scale isn't it?
|
#3
|
|||
|
|||
Re: John Deere swing machine 2954d
That looks awesome! Add some auxiliary hydraulics and you can put a grapple on it.
|
#4
|
|||
|
|||
Re: John Deere swing machine 2954d
looks great. I like the fact that you used parts from a grinder to make it. And is that sheet metal? it doesn't look aluminum.
|
#5
|
|||
|
|||
Re: John Deere swing machine 2954d
It's 1/8th scale, all the cab is made of sheet metal but I might 3d print one soon here's a couple of videos
http://youtu.be/AXz2SekeKk0 http://youtu.be/hpLV-qBpCm8 |
#6
|
||||
|
||||
Re: John Deere swing machine 2954d
2nd vid is marked private
__________________
Sharing knowledge is one thing that defies basic arithmetic logic --- the more you share, the more you get! Joe |
#7
|
||||
|
||||
Re: John Deere swing machine 2954d
Quote:
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|