|
Euro Style Trucks and Trailers A place for the Euro style trucks single and twin axle trucks and trailers... |
|
Thread Tools | Display Modes |
#11
|
||||
|
||||
Re: ScaleART - Assembling a MAN TGX/XL 6x6 tractor & Trailer
Redoing the rear lights was not as big a job as I thought. Took longer to take fenders off. Came down to a simple bit of grinding and drilling two holes.
So here a trial fit after doing one fender. (the paint did suffer from unbolting all the bits, so after taking these pics I stripped the paint off and repainted - as you can see, sanding did not work well on diamond plate) The light is at an angle because the screws are not tightened yet. Can barely see where the wire runs through the fender. Back side before cleaning up and filing of the sharp edges. Will not have to drill a bigger hole in the frame. The wires fit through the existing 2mm holes. Wire can run along the middle support of the fender and then go behind it To come out on the side and disappear in the frame. Now waiting for the new paint on the fenders to dry before reassembling the lot and running the rear light wires to the front.
__________________
Cheers, Stephan (Rakthi is the one in the avatar) Last edited by Rakthi; 07-02-2016 at 05:28 AM. |
Tags |
man tgx xl, scaleart, trailer |
Currently Active Users Viewing This Thread: 2 (0 members and 2 guests) | |
Thread Tools | |
Display Modes | |
|
|