|
Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Re: What vertical mill to buy?
Quote:
|
#2
|
||||
|
||||
Re: What vertical mill to buy?
Take some time and read the threads in the following section which is the place for this type of info:
http://www.rctruckandconstruction.co...isplay.php?f=8 |
#3
|
|||
|
|||
Re: What vertical mill to buy?
Quote:
|
#4
|
|||
|
|||
Re: What vertical mill to buy?
Well, I just recently bought a grizzly, not sure of the version at the moment, table is about 6x40 or so.
Anyhow, tooling. A good 4" vise, pref one with ability to rotate and is graduated. Parallels are a must have. Collets. Bits, lots of bits. V-blocks and 123 blocks. Clamping set. A rotory table. You will also need a dial indicator for tramming out changes in setup. About the only thing in that list that is a could get by without is the rotory table, but when you need one, you need it. Make sure you go a version with DRO or add it. It is invaluable if doing repeat work. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|