|
|
#11
02-20-2019, 04:57 PM
|
||||
|
||||
Re: Skeeters contracting services
I've tried that method before, turning down wooden dowels in the lathe, a tight belt doesn't want to sink in such a narrow groove, my slopes were about 15 degrees with a 2,5 inch width... the way Cooper did it with a wide center & 20 degree <?> angled rollers on 4 inch width belt looks like it holds a V good.
__________________
Sharing knowledge is one thing that defies basic arithmetic logic --- the more you share, the more you get! Joe 
|
| Currently Active Users Viewing This Thread: 3 (0 members and 3 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode