|
Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
|
Thread Tools | Display Modes |
#41
|
||||
|
||||
Re: Hyd Pump - What did I just buy?
So the magnetic connection will determine how much pressure it's capable of?
__________________
Sharing knowledge is one thing that defies basic arithmetic logic --- the more you share, the more you get! Joe |
#42
|
||||
|
||||
Re: Hyd Pump - What did I just buy?
I'm not sure Joe I've talked about these with Freddy awhile back , we both agreed It just will not work for what we need . I guess in a sense it will these pumps are for some labatory/medical use not requiring a lot of press I think The 2 small pumps I have came with the motor and mag drive , not changing anything on them I can't get but a drip out of the outlet . for the kind of Pressure Joe and I get out of the bigger 1's they must have 1 heck of a magnet coupling . I didn't pay alot for the few I have ,but they require modification for our use . for what the cost new , your better of buying what we have available in the hobby already . I'll use what I have , cause I have them now , but in the future will just save for the Jung set up . I was really impressed with it for the few min. I took the controls of Ed's excavator . next is valves I just keep going back and forth on buying or make . I got to speend another grand on a collet chuck and collets for the lathe so I can make the plungers being that the big chucks I have now can't hold much smaller then 3/8" . tooling seems to win out these days though .
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#43
|
||||
|
||||
Re: Hyd Pump - What did I just buy?
well i finally got 1 to a useable state
smaller original pump as I got them The 1st thing I did was cut the back of the housing down where ththe motor couples to the pump to give me more useable shaft without a slotin it for the goofy mag coupling . then made the sealing/coupling plate much like Joe did . then , using the bell that came with the motor to attach the motor much like the original . Instead of mag coupling I got the smallest bore lovejoy coupling from McM . The motor that came with it musta been gelded so , I had a 55T integy lathe motor and a RC4wth 4:1 reduction put it all together and ahlala insta pump at 15 bar pushing against the gage . bear in mind this is the smaller of the 2 type I have . it also has no relief valve .
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#44
|
|||
|
|||
Re: Hyd Pump - What did I just buy?
Hi guys im in Australia and would like to know is
there some where i can purchase one of these (ebay etc) I do know this has been asked , any help would be great Cheers Jay |
#45
|
||||
|
||||
Re: Hyd Pump - What did I just buy?
YEA EBAY I just checked , there's not any on worth useing right now meaning cheap enough to make it worth while . you gotta keep your eye out for them .
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#46
|
|||
|
|||
Re: Hyd Pump - What did I just buy?
Great thanks ihbuilder
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|