![]() |
|
Highway Trucks and Trailers On road trucks and trailers single and twin axle trucks. |
![]() |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Hey Guys! Some of you may have seen this at Indy...sitting uselessly on the work tables....finally had some time to clean it up and get some work done on it.....here are the pics...all made myself except for the front bumper...
Last edited by Tamiya Cowboy; 02-17-2011 at 08:48 PM. |
#2
|
|||
|
|||
![]()
Heres The Last 2....I still have to mount the cab, install the rest of the screw drive, wire the lights (that is the holes in the headlights and side of the cab), mount the rear taillight plate, setup the electronics, and finally, decide if im going to install a lift axle or not....all opinions and suggestions welcomed!
Thanks Zach!! |
#3
|
||||
|
||||
![]()
Nice Mack! It's always cool to see something different around the forum. We see plenty of King Haulers, but not so many of these Mack Granite builds.
__________________
Nathan |
#4
|
|||
|
|||
![]()
Thanks! It's been a tough build, but I'm proud of it!
Zach |
#5
|
||||
|
||||
![]()
Very nice looking dump! Keep it up!
__________________
DONNY EAST COAST MINI TRUCKERS |
#6
|
|||
|
|||
![]()
Thanks man! hopefully have an update this weekend!!
|
#7
|
||||
|
||||
![]()
Nice Mack DT!
The flap brackets are a nice touch.
__________________
Scott "No load is too Small" |
#8
|
|||
|
|||
![]()
Thanks! I was hoping someone would notice! haha They were fun to make...I made some new brass tan mounts but now i need to make the steps for them and solder them on...I love Brass!!!
Zach |
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|