|
Boat tech Tips/Tricks and info on all boats in here. |
|
Thread Tools | Display Modes |
#9
|
|||
|
|||
Re: Fiberglassing a Dumas Chris Craft boat?
Travis-I failed to mention the west resin doesn't sand very good. It gets really hard but tends to gum up unless you let it cure awhile. It likes heat if you need to sand it after setting overnight. I usually just waste a couple of pcs. of sandpaper to knock the top off and then it sands pretty good. Just remember not too much sanding. If you sand into the cloth then it will show up slightly.
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|