Possible Solution For Tracked Equiptment

[Trucker47]

Hey Azonic!

I think if you could send some dimensions that would be easiest seeing as you are located in Sweden and I am out In BC Canada. So it might take a while to get here! If you could maybe give some dimensions or hand draw blue prints I'll draw them up and we can from there!

I'm glad you could use this offer! I was just sitting at work thinking, hey why don't I do this? I need some tracks and Im sure everybody else could use some.

Chris

[RCP57]

So this is off topic but... What happened to your wheel loader Chris?

[Azonic]

Originally Posted by Trucker47

Hey Azonic!

I think if you could send some dimensions that would be easiest seeing as you are located in Sweden and I am out In BC Canada. So it might take a while to get here! If you could maybe give some dimensions or hand draw blue prints I'll draw them up and we can from there!

I'm glad you could use this offer! I was just sitting at work thinking, hey why don't I do this? I need some tracks and Im sure everybody else could use some.

Chris

Yea its quite a bit between us but a little package by post wouldnt take that long, maybe a week. Any how i will PM you some of the basic dimentions later today.

Like i said i would like to have triple grousers like on the 1:1 machine, i post some pics of how i like them to look.

Also, i dont know if its to complicated/time consuming to machine the track pads in one piece like my plasic ones, or if its easyer to make them separate pad+link and bolt together, what you think?

Here is how i would like them to look.