|
Electronics tech Anything to do with the electronics in a model. Lights, Radio, ESC, Servo, Basic electrical. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Powering lights from the reciver
Just wondering if it is safe to power lights (LED) from an open channel slot from a receiver? I see that there are a +,- on the reciver cover and it holds a steady voltage.
If it is safe is there a device out there that will plug into the reciver and act as an on/off stitch? For example if I have a 4 channel radio with my 4th channel un used. Is there any way to use that channel to turn my lights on or off? I'm not interested in the mfu as I just want a simple on off function Thanks for any help. |
#2
|
||||
|
||||
Re: Powering lights from the reciver
Yes, it is safe to power LEDs from an open slot on your transmitter; you'll need to install a resistor in the line between the receiver plug and the LEDs. Most LED have a max rating around 3 volts, anything over that will fry the LED. There are electronic switches that can plug into the receiver and power on or off various optional equipment.
I know of several LED light kits for aircraft that incorporate a switch with the light unit; most of the aircraft LED kits have flashing red and green LEDs as well as steady on (solid) white LEDs. |
#3
|
||||
|
||||
Re: Powering lights from the reciver
Ok thanks for answering my question..I added 9 LEDs to my cab and pulled power from the reciver but didn't think to check if that was to much for it.. I used a resistor on all leads and it worked great. I will be adding trailer lights soon and did not want to go thru all this trouble to find out I could fry something...
I will look into that switched power Thank you again Trent |
#4
|
||||
|
||||
Re: Powering lights from the reciver
I have powered the Headlights on My Robbe Linde H50 fork lift truck model from the receiver using the battery connection to power the light and a Picoswitch and used the fifth channel on the TX to turn them on and off
|
#5
|
||||
|
||||
Re: Powering lights from the reciver
thanks guys.. I searched for a pico switch and found these items.
pretty cheep too! http://www.dimensionengineering.com/...s/battleswitch http://www.dimensionengineering.com/...s/battleswitch |
#6
|
||||
|
||||
Re: Powering lights from the reciver
thats the exact one i have and works great with my rds 8000
__________________
Grabbin gears and Rollin wheels ! LETS BLOW SMOKE!! Member of the Central Plains Mini Truckers,and a Minnesota road hammer. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. Flat bedders do it with chains and straps,but now im yanking 53's To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|