![]() |
|
Construction Equipment If it digs, pushes, hauls dirt "off road" post it here. |
![]() |
|
Thread Tools | Display Modes |
#41
|
|||
|
|||
![]()
Sorry for late reply I had holiday
![]() Normaly if you mix to chanels the slave is doing the same as the master. If you press forward (+) the slave will do the same (+). If you press backwards (-) the slave will do backwards (-) In our situation the pump is running only in one direction (+). It´s not allowed to the pumb to run backwards. So if you press (+) the slave must do (+), if you press (-) the slave must do (+). So on a diagram you will get an "V". Who to configure with your sender, did you read the manual? |
#42
|
||||
|
||||
![]()
Good explanation Arnd ..I did mine with having a servo plugged into the slave channel instead of having the pump speed control so i could see the direction of travel at all times when mixing all the needed channels
|
#43
|
|||
|
|||
![]()
Hi everybody.
Yesterday I received the new cabin and interior. The cabin is made from fiber glass, the interior is 3D printed. ![]() ![]() sorry of the bad quality of the pics. |
#44
|
|||
|
|||
![]()
some more pics of the interior and the cabin.
Interior is painted and the seat is covered with leather. ![]() ![]() The doors will be set up to open. Left side is nearly finished. ![]() |
#45
|
|||
|
|||
![]()
I finished the new cabin.
![]() ![]() ![]() ![]() |
#46
|
|||
|
|||
![]()
R C Construction Group
When ever I install a hydraulic system in any of my models I put in an accumulator, just a piece of tube with 1 closed end a piston & rod coming out the other end and a spring I play with different springs until I have the on Off pressure range I need, 2 micro switches, last one turns off pump when rod is out, when rod retracts to first one the pump starts all controlled by a small reed switch, controling the start stop action of the motor. The pump only runs when not at high pressure once there it stops. I get instant response when valve opens. This gives me lots of battery life Old Guy |
#47
|
|||
|
|||
![]()
Thanks for the info. I was curious about this model.
PT |
#48
|
|||
|
|||
![]()
Hi, just an update on the RC side.
I changed my old Futaba DX18, which wasn´t able to mix the hydraulic, to a Spektrum DX10t. Nice toy. Now my digging time is longer with one batteryload. |
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|