|
Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
|
Thread Tools | Display Modes |
#10
|
|||
|
|||
Re: broken bits
If you had a broken tap or drill in an aluminum part (or brass or other non steel) you can use Alum, aluminum sulfate (dissolved in water) to dissolve the steel and not the aluminum, it's slow going. Nitric acid works faster but is not always easy to come by.
If you have taps or drills that are plugged up with aluminum you can use Red Devil Lye (dissolved in water) to dissolve the aluminum and not harm the tap.
__________________
Jeff Last edited by pugs; 11-18-2010 at 02:27 PM. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|