CAT 14M3 Motor Grader

[Tunnelmaynia]

Hemi1966
Thank you for the reply. I hadn't thought about scaling up. I was afraid of the dimension from the smaller die-cast models being to far off. I will give it a go and start drawing some things and assembling the 3d components in fusion. Thanks again.

[Hemi1966]

Originally Posted by Tunnelmaynia

Hemi1966
Thank you for the reply. I hadn't thought about scaling up. I was afraid of the dimension from the smaller die-cast models being to far off. I will give it a go and start drawing some things and assembling the 3d components in fusion. Thanks again.

Dimensions of smaller details that are impossible to cast in small scale might be slightly off, but most dimensions are correct enough.