|
|
|
|
#1
02-20-2012, 10:13 PM
|
|||
|
|||
Re: Hauling Dirt out of my basement (present day)
Joe-on your cylinder,my guess is that it wasn't clean and could have been too hot. Cleanliness is usually the problem. If you can get your hands on "sta-brite" silver solder it comes with acid flux and is low heat. If you get it really clean I think that will hold. My truck bed is steel and it is put together with the "sta-brite" and I have abused it quite severely just when sanding and grinding and finishing on it.
|
|
#2
02-20-2012, 11:38 PM
|
||||
|
||||
|
Re: Hauling Dirt out of my basement (present day)
dirty joint most likely residue from laquer thiner or oil residue that didn't come off . A little trick I learned cleaning oil off completely is use either (cold weather starting fluid ) dissolves oil real good
 . another thing , I'm sure you took the cylider all apart before soldering 
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
|
 |
| Currently Active Users Viewing This Thread: 9 (0 members and 9 guests) | |
|
|
Hybrid Mode
