|
Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Hydraulic pump pics?
Does anybody have pics of any of these miniature pumps taken apart, or exploded view, I know what a gear pump looks like, I'm just lookin for some pics of these, thanks
|
#2
|
|||
|
|||
Re: Hydraulic pump pics?
Ok, no pics, the main question is the gears, what size, where might u get them?
|
#3
|
|||
|
|||
Re: Hydraulic pump pics?
I don't have any photos other than the diagram in my other post that I will work from to try and make one ... one day. As for gears, you can make them yourself (with a lathe, milling machine and gear cutter) or buy them from various sources. A couple of common sources of gears are McMaster-Carr and SDP-Si.com (Stock Drive Products). At this stage I have no idea about gear sizes, DP and mesh.
|
#4
|
|||
|
|||
Re: Hydraulic pump pics?
The gears would be a pair of the same size, and should be special pump gears not ordinary power trans gears. The pump gears are shaped differently to make the gear pair seal up to each other better. They also need to be ground for thickness to be 0.0004" thinner than the housing depth so as not to allow oil seepage around the sides.
If I could find a source for good pump gears, I'm sure I could build one (or multiple) just haven't been able to find a good source of small ones yet.
__________________
Jeff |
#5
|
||||
|
||||
Re: Hydraulic pump pics?
Here's a pic of the inside of the pump.
The gears measure 6.90mm OD.
__________________
Joe |
#6
|
||||
|
||||
Re: Hydraulic pump pics?
wow , I guess I'll have plenty of volume with mine just hope I get the pressure
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#7
|
||||
|
||||
Re: Hydraulic pump pics?
Here are a few pics of the inside of a jung pump..same one as whats running in Eds (jammers) excavator..These will pump up to 120 bar 1680 psi
|
#8
|
|||
|
|||
Re: Hydraulic pump pics?
Nice pics guys, thanks, joe,I assume there is a another cover over those gears and all that is inside the tank! How thick are those gears roughly?
That Jung pump looks like an efficient, little more to difficult for me to make! But at 160 bar, that's nice! |
#9
|
||||
|
||||
Re: Hydraulic pump pics?
[QUOTE=johnboyee;9705]Nice pics guys, thanks, joe,I assume there is a another cover over those gears and all that is inside the tank! How thick are those gears roughly?
You are correct. Their about 4 mm.
__________________
Joe |
#10
|
|||
|
|||
Re: Hydraulic pump pics?
thanks for the info joe now i know i was going down the right path with the pump that i am plaing with as well.
__________________
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|