1/10 caterpillar 140h motor grader 3d printed

[Orange RC Works]

Originally Posted by ddmckee54

How long did it take you to get the openings in the engine covers cleaned up and ready for paint? I know you've said you sand until you're happy with things, but that would have driven me bonkers.

i had to print that side flat on the bed otherwise, if standing up, i had to clean up a lot of stuff, and that side panel is almost 26.5 cm so it had to be in 2 sections to fit on the printer bed, then i just glue the 2 sections together, the 2nd picture is the grille face down on the printer...

[Orange RC Works]

this is the complete assembly of the engine compartment