CAT 374D L

[Azonic]

Looks great, nice work as always!

[Stefan]

Very nice parts, Ari! The pace of your build is amazing.

Stefan

[9W Monighan]

Wow,coming along nicely. The wear plates and teeth on the bucket turned out very nice.

[SmallHaul]

You do fantastic work! The bucket looks incredible.

[Hemi1966]

Got the chain drive housing done

[Madda]

Where did you get that chain from?

Great job man, very tight fit there

[Hemi1966]

Originally Posted by Madda

Where did you get that chain from?

Great job man, very tight fit there

chain and sprockets are from here: http://www.conrad.com/Chain.htm?webs...167&ireusocl=1

[Azonic]

So clean, will look great assambled!

[rc_farmer]

Another fine job you are doing there........Conrad has alot of nice building stuff, but they dont ship to the U.S. of A

[Stefan]

Impressing as always! But it looks like you let the chain actually slide against the housing walls? Never seen that before. Don´t you think that will create noise and an aluminum slurry?

[Hemi1966]

Originally Posted by Stefan

Impressing as always! But it looks like you let the chain actually slide against the housing walls? Never seen that before. Don´t you think that will create noise and an aluminum slurry?

Yep, your right about that Stefan. Due a small design error I made the housing little too small, but it doesn't keep any noise and hopefully with some grease inside it don't eat it self thru the housing

[Stefan]

I see, its a bug and not a feature Well, in any case, the chain plates might dig in a millimeter or so (actually half a millimeter if you have the 6 mm pitched chains), but then the rollers start rolling on the land between the grooves and the wear rate should decrease.

[Hemi1966]

Some progress with the undercarriage. The drive end is pretty much done but the front idler still needs to be done.

[RCP57]

Sweet! You'll be digging in no time!

[dabears]

WOW awesome work!

[Madda]

Originally Posted by Hemi1966

Great work! Really impressive!

Do you have any more pictures of that motor cover or whatever is that called? You bent that radius or milled?

[Hemi1966]

Originally Posted by Madda

Great work! Really impressive!

Do you have any more pictures of that motor cover or whatever is that called? You bent that radius or milled?

That's actually a U-profile that's machined that way.

Got the idler wheel and track tension mechanism done

[Hemi1966]

Some progress

[RCP57]

Lookin good Ari, at the rate you're going you'll have this done in a couple months.

Reg

[Hofabooz]

Hi Ari

Great work and it is giving us all ideas.
Keep the update coming and thanks for sharing.

Regards

Mark