|
|
|||||||
| Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
04-21-2016, 01:28 PM
|
|||
|
|||
Re: Slewing bearing
I used a tapered bearing on the top (carries both radial and thrust load):
http://www.mcmaster.com/#standard-ba...rings/=122wlwm And I used a regular ball bearing underneath. I machined aluminum bearing holders and screwed a 72t gear-ring onto the top one. This might have been overkill, but it is super tight and it turns very smooth. Paul 
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
