|
Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Re: Need help with fittings please.
Crusher
I always use Festo fittings the small series have 4 and 6MM lines the fitting has one end threaded 5mm (I use a 8-32 tape, and 1/8 NPT, the other end is a push in for the tube. Elbows come with a swivel so you can place them beside each other, rated 150PSI but these smaller sizes will take 300PSI as that's what I run my models. Earl |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|