CAT 14M3 Motor Grader

9W Monighan · #1 12-31-2018, 09:15 AM

I see you have been using your Lampert welder on the front control arms. How well are the welds holding up? I was hoping to get one of those rigs this year but it never made it into my budgit this year.

Hemi1966 · #2 12-31-2018, 09:31 AM

Quote:

Originally Posted by 9W Monighan

I see you have been using your Lampert welder on the front control arms. How well are the welds holding up? I was hoping to get one of those rigs this year but it never made it into my budgit this year.

So far they are holding up. I was slightly worried about the welds, but now I have taken the front axle apart several times, and it's still intact. That profile is 3x4mm so the seams are quite small.

Hemi1966 · #3 01-05-2019, 06:19 AM

I got the centershift lock cylinder done

Hemi1966 · #4 01-13-2019, 03:05 AM

I got the the articulation cylinders done

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)