|
Construction Equipment If it digs, pushes, hauls dirt "off road" post it here. |
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
Re: Mack M75SX
Looking good!! And everyone thinks that running a CNC mill or lathe is just push the go button and everything comes out OK Slowing down the feedrate is not that bad of a thing to do. Recommended feeds and speeds are not all what they are cracked up to be!!!
__________________
LYNN |
#2
|
||||
|
||||
Re: Mack M75SX
yea I just looked it over clicked the circle not the point
thanks Lynn , tell me about it I tried to tell my wife that now she gets it , I just never spent so much time at the puter then the machine I cut the recomended feed down by 30% seems to work well I just worked up the next op for those trailer frames with the other frame in it 12 hrs I'm thinking I need to find a water jet guy for the basic profiles
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#3
|
||||
|
||||
Re: Mack M75SX
"Any pictures of your set up on the machine?"
Steve , as I promised also this time I decided to use a bigger EM and crank the feed up also the spindle much better time more tomorrow
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#4
|
||||
|
||||
Re: Mack M75SX
well the 2nd frame fell out of the plate this morning about 3 am
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#5
|
||||
|
||||
Re: Mack M75SX
walking beams
now these get chucked up in the lathe to turn the ends where the arch stops . there's a pic of it I just got to figure how to get it on here thanks for looking
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|