Tamiya Arocs tipper

[Brel]

Originally Posted by frizzen

Very sharp truck! Great job fitting all that into a daycab

I don't remember seeing this when it was first posted

thanks frizzen and skeeter, it was a bit of a pain squeezing the electronics into the cab, but it works fine

I changed the drive spindle and ram in the lift actuator for one with a courser thread because the original on took 1 minute to raise the bed and another to lower it, it will now lift up in thirty seconds and the same for down which will have to do, the kit supplied drive shaft is on the left and the coarser replacement is on the right and lifts the dump body up twice as fast

Originally Posted by trewq

One very nice build there!
Not sure if it is allowed to comment in this section. I see that no one has commented and I am a bit worried cause this is a great truck and it deserves more attention

trewq, thanks, I don't mind anyone commenting on my post and do appreciate positive comments