Scaleart - assembling an Arocs 8x8 roll on roll off kipper

[Rakthi]

Yes, you are right, it would have been nice to have more if not all hex fasteners. But since the phillips screws are predominantly in areas not normally visible it is not such a big deal (personal opinion). Like most companies it is a delicate balance between profit (survival) and quality.

Considering this stuff is 100% made in Germany, not known for low wages / taxes, ScaleART probably make less of a profit than the Chinese competitors who sell their stuff at half the cost.

[sneff]

Originally Posted by Rakthi

Yes, you are right, it would have been nice to have more if not all hex fasteners. But since the phillips screws are predominantly in areas not normally visible it is not such a big deal (personal opinion). Like most companies it is a delicate balance between profit (survival) and quality.

Considering this stuff is 100% made in Germany, not known for low wages / taxes, ScaleART probably make less of a profit than the Chinese competitors who sell their stuff at half the cost.

Agreed. As long as they are hidden.