|
Big Boys of the road 4x4/6x6/8x8/10x10 Trucks This forum is for those multiple axle trucks and other vehicles on and off road. |
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
Re: Liebherr LTM1800 scale 1/24
I originally was going to make my own collector rings but found one that suited.
Looking at your picture; Is the brass soldered to the aluminum? I've never tried to do that before. |
#2
|
||||
|
||||
Re: Liebherr LTM1800 scale 1/24
Quote:
Kerst |
#3
|
||||
|
||||
Re: Liebherr LTM1800 scale 1/24
Quote:
Oh, did you mean the frame? I glued the Al and brass together, but for strength a 1/4' bolt connects the brass with the center ring, a similar setup like pre-stressed concrete. I like to use AL, because it is light and easy to work with and i found very good glue. But i don't rely completely on the glue; I mostly add bolts. i made the outrigger beams from steel, because I wanted a lot of strength there. I plan to make the telescopic boom from AL too. it should work and it will flex a lot more than steel. And i would like to achieve that effect. Kerst |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|