|
Construction Equipment If it digs, pushes, hauls dirt "off road" post it here. |
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
Re: 990 cat loader
Don't you hate long load times and with these old controls. Did you repeat incrementally? Rather than separate event. But you did have 1400 holes I guess that would take up some memory that needed broken down.
|
#2
|
||||
|
||||
Re: 990 cat loader
I broke it in segments (1 group of holes at a time ) the program was close to 200,000 megs or gigs IIRC . something that long I usually run it right off the floppy drive via DNC ( as the manual calls it ) it just been terminating part way through the program lately . could be the floppy drive . I guess I'm gona have to get that usb conversion the older mill I have to load it manually it use to have a tape reader that went bad . you know ,1 made from nonobtainium
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|