Custom-making SCANIA 8X8 Tipper

[izzzul]

Hi guys, this is my first truck build, kindda to play with my EXCAV at construction sites.. build still in progress, mainly working on hyd system for the bucket lift...feel free to give input (if any)...






Refer here at my BLOG for more details..
http://my-rc-page.blogspot.com/p/blog-page.html

[Espeefan]

Wow, I like that. Very clean chassis, and well thought out plan. Your drawings look great too. I've never really seen anyone plan a truck build with drawings like that. What kind of transmission are you going to run? Modified Tamiya semi rear ends for the driven steer axles?

[izzzul]

Originally Posted by Espeefan

Wow, I like that. Very clean chassis, and well thought out plan. Your drawings look great too. I've never really seen anyone plan a truck build with drawings like that. What kind of transmission are you going to run? Modified Tamiya semi rear ends for the driven steer axles?

Using high-tork, low rpm geared motor, the same one I use for my RC Excav..for heavy Excav, i got hyd rotor/motor already..will replace that later.. and transfer case from RC4WD below...


and as for steer drive, you're right, mod the std one for now, trying the cheap way first, i got 1 set of 1/14 INTEGY full metal axles..but for now..


i hope it turn out to be ok..

[Fat Boy Fab]

Very cool, did you scratch build the dump box?

[Kaf343]

Looking cool, I like the box as well.

[izzzul]

Yes, scratch build using flat bend/press machine, it's 0.9mm SST, quite heavy the this size, with hyd lift, i hope no problem..

[Dunga_CZE]

Originally Posted by izzzul

and as for steer drive, you're right, mod the std one for now, trying the cheap way first, i got 1 set of 1/14 INTEGY full metal axles..but for now..

More details about this, please, please, please.

[izzzul]

Hi there, sorry for late reply, kindda stuck on other side of the world...

I'm customizing std TAMIYA axle, and convert them to steering axle by joining the readymade drive shaft to axle line. I copied the same method that a guy from German, trying to find the thread here, later.

[izzzul]

And now, after some times, i'd managed to complete the build. The first trial bucket that i posted before was SST using bending machines, while final one is the Al bucket...





Here's some videos:
https://www.youtube.com/watch?featur...V77Lp794#at=13

Or refer here for more pictures and videos:
http://my-rc-page.blogspot.com/

[Hockeydad]

Nice clean build. I like the hydraulics, where did you get the cylinders from?

Bryan

[mgb]

Wow, all your work is really amazing, can' get enough 8x8's.