|
Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Hydraulic System
Hi all, am going to change my Telescope Cylinder on my tipper for two rams the ones off a 4200xl but were should i mount them at the front or at the back
|
#2
|
||||
|
||||
Re: Hydraulic System
You building a scissor hoist or just a straight push?
__________________
Sharing knowledge is one thing that defies basic arithmetic logic --- the more you share, the more you get! Joe |
#3
|
|||
|
|||
Re: Hydraulic System
just a straight push
|
#4
|
||||
|
||||
Re: Hydraulic System
...no pic & vague info... what is it you're doing exactly? Is this a bobtail or a trl? Box length?
__________________
Sharing knowledge is one thing that defies basic arithmetic logic --- the more you share, the more you get! Joe |
#5
|
|||
|
|||
Re: Hydraulic System
you should put the cylinder on a partial angle and try extending it in various positions to find the best spot. it should be so the cylinders lower on an angle so the dump bed can lower as the cylinder does without any problems. it`s better to measure and do the math than to guess and end up with a fault.
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|