|
Construction Equipment If it digs, pushes, hauls dirt "off road" post it here. |
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
Re: Build an Excavator from Scratch
Very nice build. Impressive skills!
__________________
Emil G | MFZ Blocher Fendt 926 | RC4WD Volvo EC480 excavator | Carson LR 634 | Kenworth 6x6 hauler | Kenworth 6x6 dtrk My channel: To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. Construction site on Facebook: To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. Pictures on Instagram: To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#2
|
|||
|
|||
Re: Build an Excavator from Scratch
Thank you.
I'm a fan of functional gimmicks. So i've spend the last two days in the shop to make a remote controlled ladder for the operator. I think, the operator needs some handrails
__________________
Regards Ralf |
#3
|
|||
|
|||
Re: Build an Excavator from Scratch
I think it
|
#4
|
|||
|
|||
Re: Build an Excavator from Scratch
Todays work was a repair of the stick cylinder. Before the final assembling i've made the mistake to pull the rod complete to the end. During normal operations this never will happen due to the geometry of the stick.
At the end of the cylinder the piston collides with the oil input flange thereby the piston seals get damaged To open the cylinder i have to loosen the head. Sealed with loctite 542 thread sealant it just needed some hot air After replacing the piston o-rings and refilling the oil then thread sealant is applied Now I have to wait 24 Hours before the glue is cured.
__________________
Regards Ralf |
#5
|
|||
|
|||
Re: Build an Excavator from Scratch
24 hours later: The repair was successful.
The stick holds his position. After this I've made a last stress test. Mounting all the 20kg ballast as counterweight And a little mandrel press was the lifting object her weight and finally the test. lift and hold. passed. I'm very satisfied with this result. After a holiday the final work on the hull begins...
__________________
Regards Ralf |
#6
|
|||
|
|||
Re: Build an Excavator from Scratch
Detailwork.
A rough sawed and fine filed patch for the cutout of the ladder lever A door handle and handrails complete the second of four parts of the hull.
__________________
Regards Ralf |
#7
|
|||
|
|||
Re: Build an Excavator from Scratch
Hi. Nothing new due to a vacation, but today i have a first training session for my eye hand coordination.
Works a bit better but still much to learn A short clip https://vimeo.com/727432466
__________________
Regards Ralf Last edited by pufferfish; 07-06-2022 at 12:02 PM. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|