1/16 John Deere 9620rx

[davaante25]

Thank you. I don't have any implements at the moment. I plan the get the 1/16 Lemken Air Drill Solitair 9, or the 1/16 John Deere Disc 637 Flex Fold, and install firgelli actuators on them to make them functional. The build took about a week and 1/2 to finish. I would say that the hardest parts were cutting out the idler wheels, and making the main drive wheel compatible to the axle shafts. It doesnt have a good turning rate. That's the down side, its turn wide. I now have to fit the main drive wheels with teeth to catch the tracks a little better to reduce slipping when pulling.