Rear Bumpers

[skeeter]

In the pics above, where the small jam nut is, on the pintle eyelet, can you custom make one that would be 5 inches long, from that nut? I need a compensator for a PNW stylr logging truck I will be building this winter. I think.......................there I go thinking again...............IF I did math right (NOT good at math) 5 inches, in 1/14 scale should equal 9 feet of real life?

[frizzen]

Originally Posted by skeeter

In the pics above, where the small jam nut is, on the pintle eyelet, can you custom make one that would be 5 inches long, from that nut? I need a compensator for a PNW stylr logging truck I will be building this winter. I think.......................there I go thinking again...............IF I did math right (NOT good at math) 5 inches, in 1/14 scale should equal 9 feet of real life?

Depending on the thread of the pintle why not try some aluminum rods like rock crawlers use for links?

5" in 1/14 is 5.8 feet.
7.714" in 1/14 is 9 feet or 195mm

http://www.axialracing.com/products/ax30518 so if the lunette ring uses m3 x.5 then 2 of these would work, and get a m3 setscrew to connect them for 196mm.

[RCP57]

The next batch of bumpers are ready to ship....



Custom order with PMD Pintle hook



Reg