Bruder Delta loader conversion

[jerry56]

LOL Tgrzes things are tucked away but far from neat much better than they were though.
Thanks Egronvold I'm still getting the hang of this...
Frizzen I just have to get a mind set for stowing wire I guess, sometimes I run them and they look good but when I put 2 pieces together I find out the run is in the wrong place. There is a lot of pre-planning that goes into these. when you said "After you figure out component layouts" I had to laugh ... layout ???? you mean once I get all this shi* stuffed in...lol... this thing was tiny....But I'm getting better... you know I'll ask if I get stuck.
This was a fun build but if I were to do another one I think I would go all servo so I could skip the ESC's plus it would give me more room without the gearbox. When I started collecting parts for this a year ago there wasn't a ready source of CR servos you had to convert them and I wasn't ready to tackle that. Now there Hitec and Bilda both have CR servos so I think I would go that route.