|
Metal forming & tools If it bends,twists,welds,cuts & turns metal.Post it here |
|
Thread Tools | Display Modes |
#4
|
||||
|
||||
Re: Drill press fixture question...
Fin,
I did adjust the gib screws as you suggested I got them just a tiny bit too tight. I should clean and lube it and see how it goes. I cant believe I have gotten by without this thing for all these years! I do sort of miss watching stuff spin around on the end of the drill bit though! I love using the drill press now! I could NEVER have done the conversion on the little crane without it! Thanks Again, Jim |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|