|
|
|||||||
| Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
 |
|
|
Thread Tools | Display Modes |
|
#1
02-20-2014, 02:15 PM
|
||||
|
||||
Hydro motor seal question
I'm still learning the hydraulics setup on this stuff. I have not had the opportunity to actually touch or dissemble a pump. I'm thinking of making my own but need to figure out what is being used or done to seal the motor shaft in the pump housing? A lot of what I've seen (I think) motors have small shafts, pressed on gears? But I can't find any such small rotary seals to be used. Pics would be appreciated
__________________
Always wasting money, as the wife says. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. 
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
