|
Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Brushless Track Upgrade Kit
Hi can someone help me out with the wiring for the 1/12 Earth Digger Excavator Brushless Track Upgrade Kit lots of wires
|
#2
|
|||
|
|||
Re: Brushless Track Upgrade Kit
Each motor has 3 wires that will be going separately via the swivel all the way to the brushless regulator, one for each motor. So totally 6 wires through the swivel to the 2 regulators. Doesn't mater how these 3 wires are mixed, just change around 2 wires to get the motor running in opposite direction. Each regulator has a + & - wire, for the battery. Than the wires from the regulator to the receiver.
DON'T connect wrong +/- regulator cables on the to the battery => game over. |
#3
|
|||
|
|||
Re: Brushless Track Upgrade Kit
Thankyou Rimrock will get back if it works
|
#4
|
|||
|
|||
Re: Brushless Track Upgrade Kit
well well work first time thank to you Rimrock top man thanks mate
|
#5
|
||||
|
||||
Re: Brushless Track Upgrade Kit
I had that system on mine, went back to the original. The upgrade I got was better suited for 7.2 volts , I was running my system on 12 (3s) hope you have better outcome than I did.
__________________
Always wasting money, as the wife says. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#6
|
|||
|
|||
Re: Brushless Track Upgrade Kit
I can't say i follow. The slip ring has 3 red wires and 3 black. Do all the red wires go to one motor and all the black to another? Could you possibly provide a wiring diagram?
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|