Cossett
05-28-2015, 09:18 PM
Has anyone used a small toggle switch or similar between the MFU power cable and the battery so the MfU can be left on and power on/off there truck with the toggle switch ?
As I want to put the MFU control box under the hood where it cant be seen ( above the servos ), the main board in the daycab with interior above it and the battery between the chassis rails witch just fits in,
In hind sight it probably would of been easier to hing the hood but the cab has only come back from the painters again and the MFU only arrived last week so I couldnt do a proper mock up of cab /MFU
Here is the toggle switch I want to use, its a little Q11 6 pin DPDT toggle switch capable of up to 12 volts
https://www.facebook.com/ajax/mercury/attachments/photo.php?fbid=860976903981951&mode=contain&width=468&height=468
Cheers Tracy
As I want to put the MFU control box under the hood where it cant be seen ( above the servos ), the main board in the daycab with interior above it and the battery between the chassis rails witch just fits in,
In hind sight it probably would of been easier to hing the hood but the cab has only come back from the painters again and the MFU only arrived last week so I couldnt do a proper mock up of cab /MFU
Here is the toggle switch I want to use, its a little Q11 6 pin DPDT toggle switch capable of up to 12 volts
https://www.facebook.com/ajax/mercury/attachments/photo.php?fbid=860976903981951&mode=contain&width=468&height=468
Cheers Tracy