Rc4wd end loader wheels

[Bruski]

So I have been reading the forums for a while and learning a lot. My question is my end loader, how do I get the wheels off? I see the little bolts and guessing that is what need to come off but what size socket do I need?

I need to take them off so I can take the rear weights off so I can put lights in them. Mother fasteners in the wheel well need to come out but just can't get in there with the wheels on

Thanks in advance

[andyathome]

hi ,
you need to take all the small 2mm bolts on the outside ring out ( in the deep part of the wheel).
I think from memory it is a 2.5mm socket.
Be careful as the bolts arent that strong and will snap off if too much horse power is applied to them.
I dropped the whole axle out when i fitted my lights, it made the job much easier 4 cap screws holding housing and job done.

see page 9 of my thread JBC construction in this froum.

cheers andy

[Bruski]

Thanks, never thought of dropping the axle, does seem easier, duh. I don't have a 2.5mm socket either so axle dropping hopefully tomorrow. BTW, like the black on your end loader.

Thanks for the info, may have to take some pics when it's lit up.

[jack van]

if you remove just the wheels have 2 small allen keys to put in the bolt holes when you line up the screws to reinstall make life so much easier lol :D