AT9 Radio setup ?

[Just_Build_It]

I recently got a RadioLink AT9. I have it all set up with throttle, steering and 5th wheel unhooking servo working great. Now my question is on the (ch3)throttle stick it is mixed with channel 6 up and down and left and right operates ch.4. The opposite stick for steering operates only channel 1 left an right, up and down operates ch.2. How can I have the throttle only operate ch.3? I'm probably as confused as you are while trying to follow me. The truck lights will turn off if activated when I flip the transmission switch also.

I would like to have it all operating properly but I don't know my way around this type of radio setup. I would greatly appreciate your help. Thank you and I'll answer any questions the best of my knowledge.

Here's list of my channel set up:

Ch.1- steering, left and right, right stick
Ch.2- not used up/dwn right stick

Ch.3- fwd/rev(up/dwn) left stick
Ch.4- not used (left/right) left stick

Ch.5- not used, 2position switch F

Ch.6-not used but paired with ch.3

Ch.7- blank

Ch.8- lights, switch H, momentary switch

Ch.9- transmission, 3 position switch E

Ch.10- blank

[Just_Build_It]

Never mind, after a few hours of jockeying channels around and then messing with the settings I finally figured it out. I had to eliminate the usage one channel/switch that was wreaking havoc across the board. Everything is working great and just how I wanted it to.

Sorry for wasting the time that everyone spent reading this.