3D printed utility vehicle

[TheBennyB]

If you haven't seen this yet, what a cool vehicle. Think around $2000 for RTR as in the video Medic just did on it or you can go the kit route for a bit less. Would like to see what kind of weight the bucket can handle.

https://www.youtube.com/watch?v=Dx7zCoZgdPU

https://spykerworkshop.com/shop/completepackage/build-a-spykerkat/#spyker-kat

[Northern Farmer]

Here's the KAT playing the snow :cool: Looks like a lot of fun!

https://youtu.be/RPEa_3Q_8pQ

[Northern Farmer]

Had an idea...would be pretty cool to have an adapter made to fit Spyker's snowblower to Eagle's 870k loader. Think it would look pretty sick and make quick work of clearing the walkway :cool:

[scottyk]

I have the spyker snowblower on a RC truck and that thing works great! I run a brushless motor on it and I have cleared my entire 120' driveway with it a few times. It will throw snow much farther than the width of the driveway too. Not sure its wide enough to cover the track width of a loader, but it would not be hard to make custom mounts for it to fit. Thats the beauty of 3d printing tho is that it would not be terribly difficult to make the whole snowblower wider I wouldnt think.

[Northern Farmer]

That's awesome :cool:

[TheBennyB]

Yea, that would look pretty sweet.

[Northern Farmer]

Get something like this going only in 1:14 :D

http://i65.tinypic.com/2uixfuq.jpg

[Northern Farmer]

Get something like this going only in 1:14 :D

http://i65.tinypic.com/2uixfuq.jpg

Looks like someone had the same idea :eek:

https://youtu.be/x70-BsoIpks