Suitable gear mesh

[Cat966c]

Hello all; I’m at the motor mounting/motor audjusting state and I’m wondering what is a suitable gear mesh for the main drive train? Here is what I have now and I can slide a piece of printer paper through easily enough but not too easy

[Cat966c]

:thinking::confused::(Can anybody see that picture?? I did as directed but I feel it’s not working…

[Hofabooz]

HI

No I cannot see the picture try again please

[Cat966c]

How’s this

[Cat966c]

WTH? It’s not working when I want to post a pic?

[Cat966c]

Test

[Cooper]

Basically you just want a very little amount of play. If they are tight it will cause premature wear and excessive motor load. Too loose and premature wear quicker. A piece of paper cut close to same width of gear then ran between gears is basically what I do. Newspaper is thin, printer paper should do. Sandwiche it between gears tighten up and rotate it out.

https://youtu.be/xFGy8RARHN4

[Cat966c]

Ok, will do. I already put the printer paper through it and it went through cleanly. Not too loose, and not too tight.

[Cat966c]

Cool! Just did as your video said. That helped a lot, thanks!