View Full Version : Wiring up a Receiver
skullduggery
06-09-2018, 11:40 AM
Question for everyone i every new to rc trucks and i recently brought a Futaba T6L 6 channel controller and my question is what channel goes were in the receiver eg: throttle or steering or gear change. i have never used one of these controllers before or anything with so many channels :jaw:
anyone out there please help....
Wombii
06-09-2018, 10:42 PM
I can make an educated guess based on page 10 and 11 of the manual here: http://www.ripmax.com/Instructions/p-cb6l.pdf
I believe the standard setup with steering on right stick and throttle+gear on left stick would be:
channel 1 (right stick side to side): steering
channel 3 (left stick up/down): throttle
channel 4 (left stick side to side): gear
If you switch the gear servo over to the channel 5 switch you'll only get 2 gear positions. Channel 6 is the rotating knob.
vBulletin® v3.8.6, Copyright ©2000-2024, Jelsoft Enterprises Ltd.