Are you greasing the pivots of your excavator?

[Paulie]

This is a daily (or at least weekly) ritual on working prototypes

If you do grease, what is your favorite?

https://i.postimg.cc/3x50xtMj/6-28-2022-8-18-15-PM.jpg (https://postimages.org/)

https://i.postimg.cc/L8tYYjRc/6-28-2022-8-17-42-PM.jpg (https://postimages.org/)

[pufferfish]

On my selfmade excavator i‘ve used self greasing materials like brass or bronce for bolts etc.

I think, if you grease them, you will get a big mess with the mix of sand and grease.

[Paulie]

Ok
On prototypes I do see a lot of dirt on the grease that squeezes out but since they are fed grease from within (from the zerk) I guess it is no problem.

[frizzen]

Maybe try to start with something like Teflon dry-lube for the dirty areas, or Light machine oil for the better protected areas?

[RM model Mack]

A new machine arrived today :). First thing I did was pull all the pins I could and grease them. It's an easy job and IMO it is definitely "regularly scheduled maintenance" for an excavator so not worried about dirt buildup.

https://i.postimg.cc/wxJVvTc0/IMG-3410.jpg (https://postimg.cc/mhLMp4nH)

Top boom bushings just about dry

https://i.postimg.cc/Bbs1ts4V/IMG-3424.jpg (https://postimg.cc/VrGNHxSq)

squeeze out is a good thing...as long as it is cleaned up

https://i.postimg.cc/9FbyR44t/IMG-3423.jpg (https://postimg.cc/6y78Fpfy)

Machine is a 1/12 DIM PC360 and although it is a lot bigger than the 360L it weighs about the same. The 360L is very dense for sure.

https://i.postimg.cc/rwyCQG6P/IMG-3440-1.jpg (https://postimg.cc/ZCgdqd58)

https://i.postimg.cc/rsL5WxCg/IMG-3447.jpg (https://postimg.cc/xJtkVkZb)

full reach comparo

https://i.postimg.cc/C18jzmDz/IMG-3437.jpg (https://postimg.cc/cgsKz7FS)

full "up" comparo

https://i.postimg.cc/3wVX8Pks/IMG-3443.jpg (https://postimg.cc/jW6wv3Qc)