burder road roller

[lee.means]

here is my little cat roller

[lee.means]

sorry for the back pic my phone sucks

[grumpygrady]

nice conversation please show more

[lee.means]

what would like to see

[louie r/c nut]

Very nice .

[FlyingBeagle]

Would love to see more detail on how it is driven.

[justin]

Any videos of it

[Rd/Rz]

I am just finishing one of these conversions, managed to keep all the electronics in the front section . Never took the rear apart . Used 2 micro servos converted to 360 ,spektrum micro Rx ,4 cell Nimh from a receiver pak .

[Stuff]

nice!

[lee.means]

I am just finishing one of these conversions, managed to keep all the electronics in the front section . Never took the rear apart . Used 2 micro servos converted to 360 ,spektrum micro Rx ,4 cell Nimh from a receiver pak .

im just about all done i am using 3 hxt 900 micro servos. 2 vibrates from a old xbox360 and iv add about 2.0 lbs to the drums and im up to 6v

[MoRockN]

Very nice. I did a roller like this also but I wanted a drum mounted motor just like the real ones. I'll see if I can find any pictures.

[Kaf343]

Very cool roller

[grumpygrady]

Very nice. I did a roller like this also but I wanted a drum mounted motor just like the real ones. I'll see if I can find any pictures.

is there a build thread?

[MoRockN]

is there a build thread?

There isn't one as I did it before I joined this forum. But I found some pictures and I will post a build thread:D

[lee.means]

you can post them on here if u want

[5inchman]

There isn't one as I did it before I joined this forum. But I found some pictures and I will post a build thread:D

Hi, I've had one of these rollers on the bench for a year trying to work out how to fit the motors in the rolls. I would appreciate any help and pictures you could provide.

Cheers
5inch

[lee.means]

its super ez take off the roller you will need to make a cut buy the eagle so a round servo horn can go throw. (oh and you will need a round servo horn with a o-ring on it) i used o-ring w/hot glue and hot glue and a zip tie to hold it in the right place

[lee.means]

sorry my camera sucks. hope it helps

[lee.means]

sorry my camera sucks. hope it helps
see if this helps

[5inchman]

see if this helps

That is great stuff lee, i'd like to see how others have fitted motors in the drums.
You even got it to vibrate?

Regards

5inch

[lee.means]

i havent had time there sitting here what i was going to do is take a baring that is here put it in then i have about 4 lbs in each drum the wires will sit in the brace for the drum

[curlyone55]

Do you ever build and sell these?