|
|
|||||||
| Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
 |
|
|
Thread Tools | Display Modes |
|
#1
03-16-2011, 12:44 AM
|
|||
|
|||
tanks for using as starting point for cranes ,tractors or even half tracks
tanks for using as starting point for cranes ,tractors or even half tracks
has any one else seen this tanks ? http://www.raidentech.com/meuptrbbaita.html tanks for using as starting point for cranes ,tractors or even half tracks most are under $150 dollars us going to try one as a bottom for a yarder 
|
|
#2
03-16-2011, 10:02 AM
|
||||
|
||||
|
Re: tanks for using as starting point for cranes ,tractors or even half tracks
They are nice start for the tranny's and electronics but the drive sprockets and track links do not fit any of the construction vehicles that I know of.
Lynn
|
|
#3
03-16-2011, 10:20 AM
|
||||
|
||||
|
Re: tanks for using as starting point for cranes ,tractors or even half tracks
How about a yarder that was built on a Sherman tank that was on that logging show a couple years ago.
|
|
#4
03-16-2011, 12:54 PM
|
||||
|
||||
|
Re: tanks for using as starting point for cranes ,tractors or even half tracks
My bad
 I found a pic of a yarder made from a late Sherman running gear. Only problem with it would be the cost of the chassis. Tamiya Shermans are not cheap- most over $400. If someone used a late Sherman chassis, then there has to be one made from an early chassis. Early Sherman models can be had for around $150 if you can find one!!Lynn
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
