3D Printed D10T Build

[RCP57]

Originally Posted by JDH429

Rough figure on cost with shipping
2 sabertooth 2x12-150.00, 2 Figelli L16 100mm actuators 150.00, 2 motors - 85.00, 100 track pins and e clips - 120.00, misc hardware - 35.00, ABS filament- 80.00, paint - 40.00... My time - priceless.
Total if I don't need anything else and not including radio gear & battery- 660.00.

Sounds about the same cost as my Bruder dozer conversions(same electronics basically) only the ABS cost is swapped with Aluminum and the track pins are K1 chain. Building this stuff isn't as cheap as some people imagine and the time involved to design and build the parts adds up. You are doing a fantastic job on it though and I can't wait to see it pushing dirt!