D11 New Project

[titandigs]

Originally Posted by Cooper

!!!!!!!!!!!! Now that makes my mouth water!!!!!! The last picture of thouse cylinders!!!!!!!!!!

How about just using solid stock for the rails? Then you don't have to worry about a collapsed bend. It's a pain in the butt, but for bending these small diameter tubes in ss and brass I've found it easier to make my own concave bending wheels. There are a lot of hand benders and nice tools but few of them bend a tight radius our modes need without having a pile of "spare" parts . And the more I look at it the more I have to say the undercarriage on your machines are outstanding!!

Thanks Cooper,
The material for the rails is solid ss and a jig has been made from a couple of bits of flat bar and a roll pin to bend around. The hard part is getting a consistent radius.