|
|
#11
03-24-2015, 10:20 PM
|
||||
|
||||
Re: Great Dane excavating co.
Oops, it was a mess up not big mark, but bigford or mark!! Got both duhh
 . I tried to slow things down with limiting amount of valve travel (end points). Have to set some expo in the swing yet to smooth the initial part out. I oblonged the holes in the swing motor mount to get a little tighter mesh. That may just be a temporary solution and cause more wear.
__________________
Always wasting money, as the wife says. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. 
|
| Currently Active Users Viewing This Thread: 6 (0 members and 6 guests) | |
|
|
Threaded Mode