|
|
#11
12-29-2015, 07:16 PM
|
||||
|
||||
Re: Great Dane excavating co.
Question for you guys, I don't do much turning on steel,, feed is .005 rpm is 200. This is what the chips look like. I know I can push it to getting ideal blue chips, just want some advise on speeds n feeds.
  At this rate I will be here for a day, have to take gearstock from about 1.2" down to .3125". I may go with shaft and keyway but then I have to broach gears. Wanted to keep one piece shaft and gear. Lathe is 10x22 variable speed. Using insert cutter. Or is it no matter what going to be timely? I just don't know with steel cutting.
__________________
Always wasting money, as the wife says. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. 
|
| Currently Active Users Viewing This Thread: 32 (0 members and 32 guests) | |
|
|
Threaded Mode